Install Vinyl Soffit Over Open Rafters

If the soffit is to turn a corner cut and install j channel to allow 1 4 6 4mm for expansion at each of the adjoining walls and fascia boards.

Install vinyl soffit over open rafters.

Installation over enclosed eaves if the existing soffit is rotted or damaged it s best to remove it completely before installing vinyl soffit. Determine the preferred method of installing soffit at the fascia board. To make sure the level cut of the rafter tails didn t interfere with the soffit installation i drew the cut 5 1 4 inches from the short point of the plumb cut to provide plenty of clearance. Its top edge is tucked up under the shingles and its outside face is where the gutter is mounted.

If installing over an existing soffit and it doesn t have ventilation openings cut openings in it before installing the vinyl soffit in place. If the existing soffit is rotted or damaged remove it completely before installing vinyl soffit then use the instructions for open eaves. Basically installation over an enclosed eave is done much in the same manner. The advent of vinyl siding has allowed homeowners with average do it yourself skills to change the look of the exterior of their home more easily than other siding methods such as wood brick or stone.

This video includes information on preparation installation over open eaves enclosed eaves and. If you re installing perforated soffit panels and the existing soffit doesn t have openings for ventilation cut an adequate number of openings. After measuring down that distance on the plumb cut of every rafter i marked the level cut square to the plumb cut and made the cuts using a circular saw. Enclosed eave nailing strip fascia cap or coil stock j channel soffit fig 1 enclosed eave j channel soffit fig.

These are for reference points. 2 39 over open. Learn to install soffit with your vinyl siding installation. Use the following instructions for vinyl soffit and fascial installation.

Many accessories including trim soffit and fascia are available for a vinyl siding job. First remove rotted or damaged wooden soffits. Fascia and soffits finish the edges of roofs by covering the ends of the roof rafters or roof trusses where they overhang the sides of the house the fascia is the wide board that s installed on edge and runs horizontally along the edge of the roof. A soffit is a covering applied underneath the eaves of your roof.

Then use the instructions for open eaves. A soffit is the horizontal surface under a roof overhang. Using a level make pencil marks on the wall parallel with the lower edge of wood fascia board at the end of each wall. To complete the installation follow installation over open.

When installing vented soffit panels if the existing soffit doesn t have openings for ventilation cut an adequate number of openings.